Home > Shop By Vehicle > Dodge Ram / Cummins > 2013-2018 6.7L Cummins >

Pusher 3.5" MEGA Intake System with Passenger-Side Intercooler Tube for 2013-2018 Ram Cummins
Pusher 3.5" MEGA Intake System with Passenger-Side Intercooler Tube for 2013-2018 Dodge Cummins
 
Options:


Base Price $599.99




Powder Coat*:

Check out the Powdercoat page to learn more about finishes.

Intercooler Configuration:


PORTS*:


Coupler Color:


Description Technical Specs Frequently Asked Questions
 
Pusher 3.5" MEGA Intake System with Passenger-Side Intercooler Tube for 2013-2018 Dodge Cummins
Product Profile - 3.5" MEGA Intake Manifold
Pusher Install - 3.5" MEGA Intake Manifold for 6.7L Cummins Trucks
Features
Intake Manifold- the Pusher Intake Manifold is built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower EGT's, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a OEM gasket and hardware to make installing this intake extremely easy. You will need to delete all of your factory emissions equipment as the manifold does not have provisions to use any of it. This manifold is for off road use only. For an additional charge, select powdercoating colors are available on this manifold.

Intercooler Tubes - the Pusher intercooler tubes are built around 3.5" mandrel bent tubing. These tubes help optimize your factory intake plumbing by replacing the stock 2.75" driver-side and passenger-side tube. This kit also includes heavy duty 4-ply silicone couplers and stainless T-bolt clamps to make installing these tubes extremely easy. When using this kit, you do not have to try and cut the factory steel bands off the factory tubes in order to reuse the factory boots. Just loosen the factory clamps and install the supplied parts. For an additional charge, select powdercoating colors are available on this manifold

Average Customer Review: 4 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
 
So Far So Good July 27, 2018
Reviewer: Louis S. from Altoona, WI United States  
After the install I immediately went on a 1,500 mile trip testing many aspects of performance in my new intake system. I noticed quicker turbo spool and an overall decrease in temperatures, which made the trip that much more enjoyable. This product should be coupled with a new cold-air intake, to fully receive all benefits of larger diameter tubes. I also like that I am setup for future upgrades, in an inter-cooler, whenever I decide.

Only down side to this product system are the boot couplings that connect the tubing. They work just fine, but they are sized to fit exactly! They are not very long (as compared to factory setup), so they have to fit perfect or you wont get a good seal with the clamps. This made the install take much longer trying to get the tubes to line-up in the engine bay. I just wish they were cut to be longer. Other than that, I would absolutely buy again. Also, great customer service. I had many questions, that Jacob was able to answer without hesitation.

Was this review helpful to you?