Home > Shop By Vehicle > Ford Powerstroke > 1999.5-2002 7.3L Powerstroke >

Pusher Intake Manifold 1999-2003 7.3L Powerstroke
Pusher Intake Manifold 1999-2002 7.3L Powerstroke
 
Options:


Base Price $299.00




Powder Coat*:


PORTS*:


Description Technical Specs
 
Pusher two piece intake manifold for the 7.3L Powerstroke turbo diesel engines in 1999.5-2003 Ford Superduty trucks.
Features
The Pusher 7.3L Powerstroke manifold splits the poorly designed one piece factory manifold in two pieces. This drastically reduces the heat transfer between the hot compressed air exiting the turbo to the inlet V of intercooled air at the heads. The factory heater coil is deleted for increased flow as well. This manifold comes standard with instructions, two 1/8 inch NPT ports and corresponding port plugs. For an additional charge, select powdercoating colors are available on this manifold.

Average Customer Review: 5 of 5 Total Reviews: 11 Write a review.

  0 of 0 people found the following review helpful:
 
7.3 intake review June 15, 2018
Reviewer: Joey Baran from Maypearl, TX United States  
I am loving these Pusher intake!  Said with a Russian accent.
My buddies were telling me how much I would like the Pusher intake and they were right as it performs nicely and allows me to mod my truck even more with the added ports. Very nice design. Only con I had was with the install where the tube clearance took some effort to create.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
June 4, 2018
Reviewer: Juan Navarro from Forest Hill, TX United States  
Exelent service I will definitely recommend it, Installation of the product was super easy and the performance is real good

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
May 20, 2018
Reviewer: larry woodall from hermiston, OR United States  
Fit and finish is excellent
Could not be happier

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Pusher Intake Review. March 12, 2018
Reviewer: Forrest Logsdon from DAYTONA, FL United States  
I was satisfied with the intake, the build quality is good.
But i have Plenum inserts and a Ats housing on my turbo an it made it a PITA to get it lined up properly. Not the intakes fault but the Inserts put a lip above the plenum in which pushed the cold side pipe up into the hot side, i believe that knowing an aftermarket, inventory of the products that maybe paired with your item would help fitment.
But none the less not a fault just an improvement. I didnt notice a performance increase as of yet. But i DO HIGHLY RECOMMEND this split spider for anyone getting an ATS housing to cure surge. Its almost VITAL. Because certain build date ATS housings are garbage an wont aling on the factory spider properly. So this intake solves a ton of issues.
Overall, price is reasonable for the quality an fabrication. If you are planning on running Nos, Meth, or Ats housing i would say its a must. It does look nice installed aswell even tho i beat the paint up wrestling it around the inserts =/

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Excellent December 21, 2017
Reviewer: Josh Reiner from Weatherly, PA United States  
Love it. Easy to install. Could tell a difference in the way the truck runs.

Was this review helpful to you?

View All Customer Reviews